Panel Systems

CP-3 Divider System

Divider system CP-3 is a progressive wall panel system. It features a hidden vertical divider molding that minimizes molding appearance. Utilizing this system requires a 1/16” space between the panels for dimensional expansion and contraction.

CP-4 Divider System

Divider system CP-4 is a non-progressive panel system. It features a two-piece divider molding that allows for ease of panel replacement.

CP-6 Divider System

Divider system CP-6 is a progressive wall panel system. It utilizes the same base molding as the CP-3, but has an added protrusion that goes between the panels and is visible for an added attraction. The CP-6 divider system is also available with a 3mm edge treatment with radiused edges. The same edge treatment is also available utilizing the CP-3 divider system with a 1/16” reveal.

CP-7 Divider System

Divider System CP-7 is a non-progressive wall panel system. It features a one piece hat-shaped divider molding that allows for ease of panel installation or replacement. The inside of the divider molding can be concealed with a matching strip of HPL decorative laminate. An aluminum insert is also available to conceal the screws and lower portion of the divider molding.

Accessory Cap Molding

1. Can be utilized at the base to secure the panels from the bottom especially when elevated off the floor above rubber base molding.
2. The cap molding can also be utilized at the top of the panels to finish them off.
3. When utilizing a wainscoting application, the cap molding can also be utilized to finish off the top of the wainscoting.
4. This cap molding can also be used to terminate wall panel runs against door jams or windows.