Panel System Components
High Resolution downloads of all system components are available on the
CAD Download Page
|
|
|
CP-3 Divider System
Divider system CP-3 is a progressive wall panel system. It features a hidden vertical divider
molding that minimizes molding appearance. Utilizing this system requires a 1/16”
space between the panels for dimensional expansion and contraction.
|
CP-4 Divider System
Divider system CP-4 is a non-progressive panel system. It features a two-piece divider molding that
allows for ease of panel replacement.
|
CP-6 Divider System
Divider system CP-6 is a progressive wall panel system. It utilizes the same base molding as the CP-3,
but has an added protrusion that goes between the panels and is visible for an added attraction.
The CP-6 divider system is also available with a 3mm edge treatment with radiused edges.
The same edge treatment is also available utilizing the CP-3 divider system with a 1/16” reveal.
|
CP-7 Divider System
Divider System CP-7 is a non-progressive wall panel system. It features a one piece hat-shaped divider molding that allows
for ease of panel installation or replacement.
The inside of the divider molding can be concealed with a matching strip of HPL decorative laminate.
An aluminum insert is also available to conceal the screws and lower portion of the divider molding.
|
Accessory Cap Molding
- Can be utilized at the base to secure the panels from the bottom especially when elevated off the floor above rubber base molding.
- The cap molding can also be utilized at the top of the panels to finish them off.
- When utilizing a wainscoting application, the cap molding can also be utilized to finish off the top of the wainscoting.
- This cap molding can also be used to terminate wall panel runs against door jams or windows.
|